Table of Contents
Advertisement
Introduction
This chapter describes the programmable parameters, provides bar codes for programming, and
hexadecimal equivalents for host parameter programming through SSI.
Operational Parameters
The SE955 is shipped with the factory default settings shown in
default values are stored in non-volatile memory and are preserved even when the scan engine is
powered down. Changes to the factory default values can be stored as custom defaults. These values
are also stored in non-volatile memory and are preserved even when the scan engine is powered down.
To change the parameter values:
• Scan the appropriate bar codes included in this chapter. The new values replace the existing
memory values. To set the new values as custom defaults, scan the Write to Custom
Defaults bar code. The factory default or custom default parameter values can be recalled by
scanning the Set Factory Defaults bar code or the Restore Defaults bar code on
or
• Send the parameter through the scan engine's serial port using the SSI command
PARAM_SEND. Hexadecimal parameter numbers are shown in this chapter below the
parameter title, and options appear in parenthesis beneath the accompanying bar codes.
Instructions for changing parameters using this method are found in
Interface.
Parameter Menus
Table 8-1 on page 8-2.
These factory
page
Chapter 10, Simple Serial
8-7.
Advertisement
Table of Contents
