Troubleshooting; Nothing Happens When You Follow The Operating Instructions; The Scanner Emits Transmit Errors (Error Beeps After Decode) - Symbol P 370 RF Reference Manual

Troubleshooting

Nothing happens when you follow the operating instructions?

You Should
Check that the power supply is attached to the cradle.
!
Check for loose cable connections at the cradle, AC power supply, or host device.
!
Check the scanner's battery.
!
Make sure the device is programmed to read the type of bar code you want to scan.
!
Check the symbol to make sure it is not defaced.
!
Try scanning similar symbols of the same code type.
!
Be sure you're within the proper scanning range.
!
Make sure the scanner and cradle have been successfully paired.
!
Make sure you are within the proper scanning and transmission range.
!

The scanner emits transmit errors (error beeps after decode)?

You Should
Check that you are within scanning transmit range.
!
Check that the scanner is successfully paired with the cradle.
!
Check that the cradle is powered up and that it's cable connections are secure.
!
Note: If after performing these checks the symbol still does not scan, contact
your distributor or call the Symbol Support Center. See Symbol
Support Centers on page page x for the telephone number.
Operation
3-17