Counting Control Output On/Off Operations; Control Output On/Off Count Function - Omron E5CN User Manual

Counting Control Output ON/OFF Operations

Advanced Function Setting Level
Parameter
init
Initialization
off
PF Setting
pf
a-m
PF Setting
pf
pfdp
Monitor/Setting
pfd1
Item 1
1
pfd1 Monitor/Setting
Item 1
7
Initial Setting Level
Input Type
in-t
5
Operation Level
C
25
alm
100
Monitor/Setting Item Level
Monitor/Setting
C
al-1
Item Display 1
0

4-20 Counting Control Output ON/OFF Operations

4-20-1 Control Output ON/OFF Count Function

128
3. Press the D Key to enter the password ( − 169). It is possible to move to
the advanced function setting level by either pressing the M Key or wait-
ing two seconds without pressing any key.
4. Press the M Key to select the PF Setting parameter.
5. Press the U Key to select PFDP (Monitor/Setting Item).
6. Press the M Key to select the Monitor/Setting Item 1 parameter.
7. Press the U Key to select 7 (Alarm Value 1).
8. Press the O Key for at least one second to move from the advanced
function setting level to the initial setting level.
9. Press the O Key for at least one second to move from the initial setting
level to the operation level.
10. Press the PF Key to display Alarm Value 1.
With Control Output 1 and 2 ON/OFF outputs (relay outputs or voltage outputs
for driving SSR), the number of times that a control output turns ON and OFF
can be counted. Based on the control output ON/OFF count alarm set value,
an alarm can be output and an error can be displayed if the set count value is
exceeded.
The default setting of the Control Output ON/OFF Alarm Setting parameter is
0. ON/OFF operations are not counted when this parameter is set to 0. To
enable counting ON/OFF operations, change the setting to a value other than
0.
Section 4-20