Omron E5CN User Manual page 223

Initial Setting Level
Note
See
See
sqr
Extraction of Square Root Enable
Function
Setting
See
See
amov
Move to Advanced Function Setting Level
Function
See
See
198
(1) PRST (Program Start) can be set even when the Program Pattern param-
eter is set to OFF, but the function will be disabled.
(2) This function can be set for heating/cooling control, but the function will
be disabled.
■ Related Parameter
SP0 to SP3 (adjustment level): Page 170
Number of multi-SP uses (initial setting level): Page 196
This parameter enables and disables square root extraction.
Setting range
on: Enabled, off: Disabled
■ Related Parameter
Extraction of square root low-cut point (adjustment level): Page 178
• Set the Move to Advanced Function Setting Level parameter set value to
" − 169."
• Move to the advanced function setting level either by pressing M Key or
O Key or by waiting or two seconds to elapse.
■ Related Parameter
Initial setting/communication protect (protect level): Page 144
An analog input must be supported.
Default
None
The Initial Setting/Communications
Protect parameter must be set to 0.
Section 5-7