Omron E5CN User Manual page 184

Operation Level
al3h
Alarm Value Upper Limit 3
al3l
Alarm Value Lower Limit 3
Function
Setting
See
See
o
MV Monitor (Heating)
Function
Monitor
See
See
These parameters independently set the alarm value upper and lower limits
when the mode for setting the upper and lower limits is selected for the Alarm
3 Type parameter (initial setting level).
• This parameter sets the upper and lower limit values of alarm 3.
• During temperature input, the decimal point position depends on the cur-
rently selected sensor, and during analog input it depends on the Decimal
Point parameter setting.
Setting range
−1999 to 9999
EU
■ Related Parameters
Input type: Page 184, Scaling upper limit, Scaling lower limit, Decimal point:
Page 186, Alarm 3 type: Page 193 (initial setting level), Standby sequence
reset: Page 202, Auxiliary output * open in alarm: Page 203, Alarm 3 hystere-
sis: Page 192, Alarm 3 latch: Page 208 (advanced function setting level)
This parameter is used to check the manipulated variable for the heating con-
trol output during operation.
• This parameter cannot be set.
• During standard control, the manipulated variable is monitored. During
heating/cooling control, the manipulated variables on the control output
(heating) is monitored.
• The default is OFF and the manipulated variable is not displayed.
Control
Standard
Heating/cooling
■ Related Parameters
MV display (advanced function setting level): Page 208
Alarm 3 must be assigned.
The alarm 3 type must not be 1, 4, or
5.
Unit Default
0
The MV Display parameter must be
set to ON.
Monitor range
−5.0 to 105.0
%
0.0 to 105.0 %
Section 5-3
Unit
159