Initial Setting Level
tr-t
Transfer Output Type
Setting
See
See
194
• This parameter sets the transfer output type.
• The operation is shown in the following table.
■
Transfer Output Destination
Control output 1
Current output
• Relay output
• Voltage output (for driving
SSR)
■ Precision and User Calibration
Simple transfer output
Transfer output type
OFF
Set point
Set point during SP ramp
PV
MV monitor (heating)
MV monitor (cooling)
]
■ Related Parameter
Transfer output upper limit, Transfer output lower limit (initial setting level):
Page 195
There must be a transfer output or a
current output.
Control output 2
• No
• Relay output
• Voltage output (for driving
SSR)
• No
• Relay output
• Voltage output (for driving
SSR)
Precision
Not specified.
off
sp
sp-m
pv
mv
c-mv
Section 5-7
Transfer output
destination
Control output 1
No
User calibration
Not supported.
Default
off