Table of Contents
Advertisement
Default Ring Type
To change the Default Ring Type for the IP phone:
•
Press the
button, then select 3. Phone Settings then 2. Ring Settings
•
Select 1. Default Ring Type.
•
Scroll through Ring Types using the Down softkey. Press the Play
softkey to hear the selected tone.
•
Press the Select softkey to change to the selected Ring Type.
•
To configure another parameter, press the Back softkey to continue
or press the
button to exit the configuration menu.
Line Ring Setting
To adjust the Ring Type for a line:
•
Press the
button, then select 3. Phone Settings then 2. Ring Settings.
•
Dial the line number plus one (2 for Line 1 or 3 for Line 2), or move the cursor to Line n Configuration
using the Down softkey and press the Select softkey. The value of n is the line button number.
•
Press the
digit, or move the cursor to 1. Ring Type using the Down softkey and press the Select
softkey.
•
Select the Ring Type using the Down softkey. Press the Play softkey
to hear the selected tone. The Disable Ringer selection turns the
ringer off for incoming calls on the line. The Set as Default uses the
Default Ring Type for incoming calls on the line as specified in the
previous Default Ring Type section.
•
Press the Select softkey to save the selection.
•
To configure another parameter, press the Back softkey to continue or press the
configuration menu.
Delayed Ring
The phone can delay when the audible ring tone is played for incoming calls by up to 10 seconds. To
configure the Delayed Ring option:
•
Press the
button, then select 3. Phone Settings then 2. Ring Settings.
•
Move the cursor to Line 1 Settings using the Down softkey and press the Select softkey. Repeat for
Line 2.
•
Press
or move the cursor to 2. Delayed Ring Timer using the Down softkey and press the Select
softkey.
•
Enter the delay time as 0 to 10 seconds in 1-second increments.
0 provides no delay; the ring signal is immediate.
•
Press the OK softkey to save the delayed ring setting.
•
To configure another parameter, press the Back softkey to continue
or press the
button to exit the configuration menu.
Disable Ringer
The FortiFone-450i/FortiFone-550i can be programmed not to ring when an incoming call is received. It
will still light up the LCD, light up the Incoming Call Indicator and show the Caller ID.
To disable the ringer:
•
Press the
button, then select 3. Phone Settings, then 3. Disable Ringer
•
Press the Yes softkey to turn the ringer off, or press the No softkey to leave the ringer enabled.
F O R T I F O N E - 4 5 0 i A N D F O R T I F O N E - 5 5 0 i T E L E P H O N E U S E R G U I D E
FortiFone-550i screen
FortiFone-550i screen
button to exit the
FortiFone-550i screen
2 9
Advertisement
Table of Contents
Troubleshooting
