Table of Contents
Advertisement
PHONE SETTINGS
Under the Phone Settings menu item, the user parameters listed below can be changed.
1 — LCD Contrast
2 — Ring Settings
3 — Disable Ringer
4 — Headset Auto Mode
5 — Programmable/Flexible Key Settings
6 — Time Configuration
7 — Firmware Update
8 — Speed Dial Number
9 — Key Tone
10 — Language
LCD Contrast
The contrast of the LCD is adjustable for best viewing angle.
To adjust the LCD contrast:
•
Press the
button, select 3. Phone Settings then 1. LCD Contrast.
•
Press the Down softkey to decrease the contrast, or press the Up
softkey to increase the contrast.
•
To configure another parameter, press the Back softkey to continue
or press the
button to exit the configuration menu.
Ring Settings
The IP phone has 9 ring tones and a no ring (Disable Ringer) option for incoming call notification. There is
also the option to assign each phone book record one of the ring tones for inbound calls. The Default Ring
Tone is used when a ring tone is Set as Default or not defined for a line or phone book record.
In quieter environments, it might be useful to delay the ring signal on incoming calls. Ringing can be
delayed by up to 10 seconds. The LED light associated to your extension will flash immediately for all
incoming calls.
Default Ring Type
To change the Default Ring Type for the IP phone:
•
Press the
button, then select 3. Phone Settings then 2. Ring Settings
•
Select 1. Default Ring Type.
•
Scroll through Ring Types using the Down softkey. Press the Play
softkey to hear the selected tone.
•
Press the Select softkey to change to the selected Ring Type.
•
To configure another parameter, press the Back softkey to continue
or press the
button to exit the configuration menu.
2 8
F O R T I F O N E - 3 5 0 i T E L E P H O N E U S E R G U I D E
Advertisement
Table of Contents
Troubleshooting
