Table of Contents
Advertisement
WALL MOUNTING
The FortiFone-450i/FortiFone-550i phone supports wall mounting via the base of the phone housing. Wall
mount the FortiFone-450i/FortiFone-550i using the instructions below in Figure 4.
•
Mark and drill two 7 mm (5/16") holes for plastic wall anchors (not included) with a vertical
separation of 10 cm (4").
•
Insert two anchors into the holes, then insert and tighten the two screws (not included) leaving about
2.5 mm (1/8") exposed.
•
Attach all wiring to the phone.
•
Slide the phone over the screws and ensure the phone is secure. Note it may be necessary to remove
the phone and tighten or loosen the screws for secure mounting. Also note, the stand must not be
attached to the phone when mounting on a wall.
•
Remove the handset hook from the phone as shown in the figure below. Reverse the hook and re-
install in the phone so that the hook catches the groove in the handset receiver.
•
Complete all wiring.
Figure 4: FortiFone-450i/FortiFone-550i wall mount installation
PROVISIONING THE FORTIFONE-450i/FORTIFONE-550i WITH FORTIVOICE
If using the phone with FortiVoice, please refer to Adding IP Phones in Chapter 2 of the FortiVoice User
Guide for configuring the extensions in the FortiVoice software.
PROVISIONING THE FORTIFONE-450i/FORTIFONE-550i FOR USE WITH AN
ALTERNATE SYSTEM
The FortiFone-450i/FortiFone-550i phone supports manual configuration when the automated process is
not available. As a minimum, the FortiFone-450i/FortiFone-550i requires the information below for proper
operation.
Line 1 SIP parameters including:
•
Line 1 SIP call server IP address
1 2
F O R T I F O N E - 4 5 0 i A N D F O R T I F O N E - 5 5 0 i T E L E P H O N E U S E R G U I D E
Advertisement
Table of Contents
Troubleshooting
