Attaching The Stand - Fortinet FortiFone-450i User Manual

Wiring Chart
1 LAN Connect the IP phone LAN port to the LAN wall jack with the provided Ethernet cable.
2 PC Optionally connect the IP phone PC port to your desktop PC with an Ethernet cable
(not supplied).
3 Power If the LAN port supports PoE then the power adapter is not required. If PoE is not supported on
the LAN, connect the power adapter to the power jack on phone.
4 Headset Optionally connect a headset to the RJ22 headset jack on the phone.
We strongly recommend the use of an amplified headset.
5 Handset Connect the handset cord to the handset and the handset jack on the phone.

ATTACHING THE STAND

The angle of the phone is set by the attachment of the provided stand in one of two positions
(30° or 55°).
To attach the stand,
1. Choose the desired angle for the phone.
2. Align the tabs on the stand with the notches in the base of the phone.
3. Push the stand upward in the slot as far as it can go until properly attached.
55° angle
Figure 3: Installing the foot stand
F O R T I F O N E - 4 5 0 i A N D F O R T I F O N E - 5 5 0 i T E L E P H O N E U S E R G U I D E
30° angle
1 1