Device Information; Table 22 Viewing/Entering Device Information Data - Honeywell ST 3000 User Manual

Device Information

Device information menu contains important data for device identification, such as transmitter type, device
tag, serial numbers and revision numbers of the transmitter. Some data is fixed and is read only for
identification purposes. Table 22 outlines the steps for accessing data under the device information menu.
Step
1 From "Online" menu, select "Device setup" and press right arrow key.
2 Scroll down to "Basic setup" and press right arrow key.
3 Scroll down to "Device Information" and press right arrow key.
At "Device Information" display, use the [ ⇑ ] and [ ⇓ ] keys to scroll through available parameter
4
selections listed below.
5 When the desired parameter is highlighted, press right arrow key.
Note: If the parameter value is highlighted with a blinking cursor, the value can be changed.
Enter a new value, if desired and press ENTER.
Note: Pressing ESC will cancel action without changing selection.
Either:
6
• press SEND to download change to transmitter, or
• go to another procedure and continue making changes.
10/05

Table 22 Viewing/Entering Device Information Data

Parameter
Manufacturer *
Model *
Measurement type *
PROM ID *
Tag
Date
Descriptor
Message
Write protect **
Final assembly number
Device ID *
Revision numbers *
* This data is fixed and cannot be changed by reconfiguring the transmitter.
** Write protection is selected by changing a jumper on the transmitter PWA. See Section 8.
ST 3000 HART Transmitter Release 300 User Manual
6— Configuration - Device Information
Action
Value
Honeywell
ST3000
Pressure sensor type (DP, GP, AP)
10-digit PROM ID number
PT3011 (or enter an 8 character tag name if one is not
shown)
Enter date
Up to 8 character description
Key in a message (up to 32 characters), if desired.
No (or Yes)
Up to an 8 digit number
First 7 characters of PROM ID
Universal rev 2
Field device rev 1
Software rev 1
59