Figure 20 Smart Meter Display With All Indicators Lit - Honeywell ST 3000 User Manual

- Making Initial Checks
Local smart meter display indications
If your ST 3000 transmitter is equipped with the smart meter option, you can check the status of all the
indicators on the local smart meter LCD display by cycling power to the transmitter. The meter runs a brief
self-test whenever power is applied to the transmitter. All the display indicators are lit during the self-test
as shown in Figure 20. (Note that the display may revert to dashes (– – –) after the self-test until the
transmitter initializes all its functions.)
Please refer to Table A-2 in Appendix A for a description of the pushbuttons on the meter face. Appendix
A in this manual contains procedures for setting up the meter display, as well as descriptions of the meter
indicators, with examples of typical display indications and error codes. Use the communicator to check the
transmitter's status.
44
V A R
SEL.
0
18 8
SP AN
-
.
OUTPUT MODE
ZERO
CHECK STATUS
KNOWN VALUE

Figure 20 Smart Meter Display with All Indicators Lit.

ST 3000 HART Transmitter Release 300 User Manual
UPPE R
VALUE
%
100
8 0
UNITS
.
%
S E T
FLOW
ANALOG
In H O
2 LOWER
K VALUE
GPH mmHg
A
GPM PSI
10/05