Honeywell ST 3000 User Manual page 33

Step
2 Position bracket on 2-inch (50.8 mm) horizontal or vertical pipe, and install "U" bolt around pipe
and through holes in bracket. Secure with nuts and lockwashers provided.
Example - Angle mounting bracket secured to horizontal or vertical pipe.
3 Align appropriate mounting holes in transmitter with holes in bracket and secure with bolts and
washers provided.
If transmitter is ...
−
−
−
−
Note: If the meter body is hexagonal, you must use the additional bracket supplied. If meter
4 Loosen set screw on outside neck of transmitter one full turn. Rotate electronics housing in
maximum of 180 degree increment in left or right direction from center to position you require
10/05
Mounting
Bracket
Horizontal Pipe
DP type with double-ended process heads and/or remote seals, then use alternate
mounting holes in end of heads
GP or AP with single-ended head, then use mounting holes in side of meter body.
In-line GP or AP, then use smaller "U" bolt provided to attach meter body to bracket. See
figure below.
Dual-head GP or AP, then use mounting holes in end of process head.
Meter Body
Smaller
"U" bolt
body is round, discard the bracket.
ST 3000 HART Transmitter Release 300 User Manual
4— Installation - Mounting ST 3000 Transmitter
Action
Nuts and
Lockwashers
U-Bolt
Vertical Pipe
U-Bolt
Inline Models
Use bracket for
hexagonal meter body
Nuts and
Lockwashers
Mounting
Bracket
19