4- Installation; Overview; Mounting St 3000 Transmitter - Honeywell ST 3000 User Manual

Overview

About this section
This section provides information about installing the ST 3000 transmitter. The topics in this section
include:
•
Mounting the ST 3000 transmitter - various mounting methods are described and can be used
depending upon the transmitter type.
•
Piping the transmitter to the process – connecting the transmitter meter body to the process piping or
tank connection.
•
Wiring the transmitter – connecting the loop wiring and ground conductors to the transmitter, and
information is given on connecting local and remote indicating meters to the transmitter.

Mounting ST 3000 Transmitter

Summary
You can mount all transmitter models (except flush mount models and those with integral flanges) to a
2-inch (50 millimeter) vertical or horizontal pipe using our optional angle or flat mounting bracket, or a
bracket of your own. Flush mount models are mounted directly to the process pipe or tank by a 1" weld
nipple. Those models with integral flanges are supported by the flange connection.
Figure 7 shows typical bracket mounted and flange mounted transmitter installations for comparison.
Dimensions
Detailed dimension drawings for given transmitter series and types are listed in Section 13 in this manual
for reference. Note that abbreviated overall dimensions are also shown in the specification sheets for the
given transmitter models.
The procedures following assume that the mounting dimensions have already been taken into account and
the mounting area can accommodate the transmitter.
10/05
4— Installation
ST 3000 HART Transmitter Release 300 User Manual
4— Installation - Overview
17