Adjusting The Footplate Height; Adjusting Calfpad Depth - Invacare Action2 NG Service Manual

SECTION 2—FRONT HANGERS

Adjusting the Footplate Height

1. Unscrew locking bolt (5 mm Allen key and 10 mm Spanner).
2. Position the footrest assembly to the desired height.
NOTE: A 50 mm clearance between the bottom of the footplate and the ground/floor
MUST be maintained at all times.
3. If the distance between the bottom of footplate and the ground/floor is not 50 mm
minimum, adjust footrest tube accordingly.
4. Using the locking bolt with 5 mm Allen key and 10 mm Spanner, secure the
footrest tube to the footrest support. Securely tighten (5 Nm).
5. If necessary, repeat STEPS 2
Adjusting Calf pad Depth
4. Remove the Locking Screw B that secure the calf pad to the calf pad bracket.
5. Insert Locking Screw B through one of three calf pad bracket mounting holes.
6. Using the Locking Screw B secure the calf pad to the calf pad bracket.
7. If necessary, repeat STEPS 1
Calf pad
FIGURE 2.5 Adjusting Elevating Legrest Height and Calf pad Height/Depth
4 to adjust remaining footrest.
-
3 to adjust remaining calf pad assembly.
-
1 0
Knob
Locking Screw B
(M6)
Locking Bolt A
(M6)
50 mm mini