Section 9-Footboard Assembly; Removing/Installing The Footboard Assembly; Removing; Installing - Invacare Pronto M71 Jr. with SureStep Owner's Operator And Maintenance Manual

SECTION 9—FOOTBOARD ASSEMBLY
SECTION 9—FOOTBOARD
ASSEMBLY
After any adjustments, repair or service and before use, make sure that all attaching
hardware is tightened securely - otherwise injury or damage may result.
Before performing any maintenance, adjustment or service, verify that On/Off
switch on the joystick is in the Off position.
DO NOT stand on the flip-up footboard. When getting in or out of the wheelchair,
make sure that the flip-up footboard is in the upward position.
Limited clearance between footboard and caster - The user's feet MUST remain on
the footboard while operating the wheelchair. If the user's feet are allowed to rest
off the side of the footboard they may come in contact with the caster possibly
resulting in injury.
Pinch point may occur when rotating the footboard assembly.

Removing/Installing the Footboard Assembly

NOTE: For this procedure, refer to FIGURE 9.1 on page 57.

Removing

1. Remove the quick-release pin that secures the footboard assembly to the wheelchair
frame by depressing the button while sliding the pin out.
2. Remove the footboard assembly from the wheelchair frame.

Installing

Make sure the detent balls of the quick-release pin are fully released beyond the
outer edge of the tube before operating the wheelchair. Otherwise, injury and/or
damage may result.
Keep detent balls clean.
1. Position the footboard assembly onto the wheelchair frame so that the mounting holes
in the wheelchair frame align with the desired mounting holes in the footboard
assembly.
2. Install the quick-release pin by depressing the button while sliding the pin in.
® ™
Pronto M71 Jr. with SureStep
WARNING
WARNING
® 56
Part No 1122147