Center-Mounted Footboard; Removing/Installing The Footboard Assembly - Invacare Pronto M41 Series User Manual

Adjusting depth and angle
The headrest can be further adjusted for depth and angle
via the articulating hardware.
• 4 mm Allen key
• 5 mm Allen key
1. Loosen screws and clamping levers of dual link
adjustment assembly A and screws of upper and lower
rotational pivots B.
2. Set headrest to desired position.
3. Re-tighten screws and clamping levers.
1553378-G

5.10 Center-mounted footboard

WARNING!
After any adjustments, repair or service and
before use, make sure that all attaching
hardware is tightened securely - otherwise injury
or damage may result.
– Before performing any maintenance,
adjustment or service verify that on/off switch
on the joystick is in the off position.
– DO NOT stand on the flip-up footboard. When
getting in or out of the wheelchair, make sure
that the flip-up footboard is in the upward
position.
WARNING!
Limited clearance between footboard and caster
– The user's feet MUST remain centered on the
footboard, away from the footboard sides,
while operating the wheelchair. If the user's
feet are allowed to rest off the side of the
footboard they may come in contact with the
caster possibly resulting in injury.

5.10.1 Removing/Installing the footboard assembly

WARNING!
Pinch point may occur when adjusting the
footboard
Setup
51