Table of Contents
Advertisement
Adjustable ASBA Seats
7.35 Adjusting the Seat Frame Mounting
Position
Removing/Installing the
Seat Pan
1.
Remove the seat cushion (not shown).
Remove the two socket screws A securing the seat pan B to
2.
the seat frame C.
3.
Remove the eight socket screws D, ground washers E and
four plates F securing the seat frame G to the seat-to-floor
bracket H.
56
Adjusting the Seat Frame
Mounting Position
4.
Perform one of the following to ensure the seating system is in
the proper mounting position:
Some front rigging and seat depth combinations may not
allow for the 1-inch gap. In this situation, position the
seat frame as far back as possible.
•
Wheelchairs with Swing Away Front Rigging - Position
the seat frame as far as possible towards the rear of the
wheelchair. Leave 1 to 1½-inch of clearance between the
front riggings and the front casters in all caster positions).
•
Wheelchairs with Manual Center Mount Front Rigging -
Position the seat frame as far as possible towards the rear
of the wheelchair. Leave 1 to 1½-inch of clearance between
the center mount front riggings and the front shroud.
5.
Secure the seat frame mounting brackets to the seat-to-floor
brackets with the eight socket screws, ground washers and four
plates. Torque to 13 ft-lbs ± 20%.
6.
Position the seat pan onto the seat frame.
7.
Secure the seat pan to the seat frame using the two socket
screws.
8.
Install the seat cushion (not shown).
1143192-L-03
Advertisement
Table of Contents
