Van Seat Service Procedures; Adjusting The Back Angle; Adjusting The Seat Position On Van Seat Frame - Invacare Pronto M71 Service Manual

Van Seat Service Procedures

Adjusting the Back Angle

NOTE: For this procedure, refer to
FIGURE 4.17.
1. Lift up on the release handle and adjust
back to desired angle.
2. Let go of the release handle to lock the
back in position.

Adjusting the Seat Position on Van Seat Frame

For users over 250 lbs: The seat MUST be mounted in the furthest rearward
position and the front seat posts MUST be in the 1-inch raised position or lower
mounting holes A or B. Refer to Table: Available Mounting Holes on page 32 for
available mounting positions
DO NOT adjust the rear seat posts higher than the front seat posts.
NOTE: For this procedure, refer to FIGURE 4.18 on page 52.
1. Remove the seat assembly. Refer to Removing/Installing the Seat Assembly on
page 30.
2. Remove the four bolts, four coved washers and two spacers securing the van seat to
the seat frame.
3. Separate van seat from seat frame.
4. Refer to FIGURE 4.18 to determine the correct mounting holes to achieve the desired
seat position on the seat frame.
5. Align the van seat mounting holes determined in STEP 4 with the seat frame mounting
holes.
6. Secure the van seat to the seat frame using the four bolts, four coved washers and two
spacers. Securely tighten.
7. Reinstall the seat assembly. Refer to Removing/Installing the Seat Assembly on
page 30.
Part No 1118377
All manuals and user guides at all-guides.com
WARNING
51
SECTION 4—SEAT ASSEMBLY
Back
Release
Handle
FIGURE 4.17 Adjusting the Back Angle
Pronto® M71™