Verify Mode - Omron VARISPEED F7 User Manual

Verify Mode

The Verify mode is used to display any parameters that have been changed from their default settings in a pro-
gramming mode or by autotuning. If no parameter setting has been changed the display will show "None
Modified"
In Verify Mode the same procedures as in the Programming Mode can be used to change parameter settings.
The parameter A1-02 is the only parameter from the A1-
the other A1-
Example Operations
In the example below the following settings have been changed from their default settings:
b1-01 (Reference Selection)
•
3
C1-01 (Acceleration Time 1)
•
E1-01 (Input Voltage Setting)
•
E2-01 (Motor Rated Current).
•
Mode Selection Display
-ADV-
** Main Menu **
-VERIFY-
** Main Menu **
-A.TUNE-
** Main Menu **
-DRIVE-
-QUICK-
** Main Menu **
10
3-
Parameters will not be displayed as changed parameters.
MENU
Programming
MENU
Modified Consts
ESC
MENU
Auto-Tuning
MENU
** Main Menu **
Operation
MENU
Quick Setting
MENU
Fig 3.7 Operations in Verify Mode
group, which will be displayed in Verify Mode,
Monitor Display
A B
-VERIFY-
Reference Source
b1-01=0 *0*
Terminals
"1"
ESC
-VERIFY-
Accel Time 1
C1-01=200.0sec
(0.0 ~ 6000.0)
"10.0sec"
ESC
-VERIFY-
Input Voltage
E1-01=190VAC
(155~255)
"200VAC"
ESC
-VERIFY-
Motor Rated FLA
E2-01= 2.00A
(0.32~6.40)
"1.90A"
ESC
A B
Setting Display
-VERIFY-
Reference Source
b1-01= 0 *0*
Terminals
"1"
-VERIFY-
Accel Time 1
200.0sec
C1-01= 0
(0.0 ~ 6000.0)
"10.0sec"
-VERIFY-
Input Voltage
E1-01= 190VAC
(155~255)
"200VAC"
-VERIFY-
Motor Rated FLA
E2-01= 2.00A
(0.32~6.40)
"1.90A"