Omron VARISPEED F7 User Manual page 325

Writing Parameter Set Values Stored in the Digital Operator to the Inverter (COPY)
To write parameter set values stored in the Digital Operator to the Inverter, use the following method.
Step
No.
1 Press the MENU Key and select advanced programming mode.
2 Press the DATA/ENTER Key.
Press the Increment and Decrement Key until parameter o3-01 is displayed
3
(Copy Function Selection).
4 Press the DATA/ENTER Key and select the constants setting display.
5 Change the set value to 2 using the Increment Key.
Set the changed data using the DATA/ENTER Key. The COPY function will
6
start.
6
If the COPY function ends normally, "End" is displayed on the Digital Opera-
7
tor.
8 The display returns to o3-01 when a key is pressed.
If an fault is displayed, set the parameters again. Refer to
for corrective actions.
142
6-
Explanation
page 7-18, Digital Operator Copy Function Faults
Digital Operator Display
-ADV-
** Main Menu **
Programming
-ADV-
Initialization
A1 - 00 = 1
Select Language
-ADV-
COPY Function
o3 - 01 = 0
Copy Funtion Sel
-ADV-
Copy Function Sel
o3-01= 0
*0*
COPY SELECT
-ADV-
Copy Function Sel
o3-01= 2
*0*
OP INV WRITE
-ADV-
COPY
INV COPYING
OP
-ADV-
COPY
COPY COMPLETE
-ADV-
Copy Function Sel
o3 -
01 =0
*0*
COPY SELECT