2A1/2
(5) Adjusting the DF leading edge registration
Perform the following adjustment if there is a regular error between the leading edge of the original and the copy image.
U034
U066
(P. 1-6-12)
(P. 1-6-29)
Caution:
Before making the following adjustment, ensure that the above adjustments have been made in maintenance mode.
Procedure
Enter maintenance mode.
Enter "071" using the copy exposure
adjustment keys or zoom +/- keys.
Press the start key.
Select "Exp. 1" (DF leading edge
registration) using the copy
exposure adjustment keys.
Press the printer key and the machine
enters the test copy mode.
Place an original on the
DF and make a test copy.
Is the image correct?
Press the stop/reset key
to exit maintenance mode.
1-6-50
U071
Start
No
Yes
End
Original
example 1
Figure 1-6-90
Press the start key.
The new setting is stored.
• For copy example 1,
increase the value using
the zoom (+) key.
• For copy example 2,
decrease the value using
the zoom (-) key.
Setting range: –25 – +25
Initial setting: 0
Changing the value by 1 moves
the copy image by 0.254 mm (15 cpm)/
0.295 mm (18 cpm).
Copy
Copy
example 2