Adjusting The Amount Of Slack In The Paper - Kyocera Mita KM-1810 Service Manual

2A1/2

(4-5) Adjusting the amount of slack in the paper

Make the following adjustment if the leading edge of the copy image is missing or varies randomly, or if the copy paper is
Z-folded.
Procedure
Start
Enter maintenance mode.
Enter "051" using the copy exposure
adjustment keys or zoom +/- keys.
Press the start key.
Select the item to be adjusted using
the copy exposure adjustment keys.
Exp.1 (lit): Drawer
Exp.3 (lit): Bypass tray
Exp.5 (lit): Optional drawer
Press the printer key and the machine
enters the test copy mode.
Press the start key
to make a test copy.
Is the leading
edge of the image missing
or varying randomly (copy
example 1)?
Is the copy
paper Z-folded (copy
example 2)?
Press the stop/reset key to
exit maintenance mode.
1-6-PB
Yes
No
Yes
Decrease the value using the zoom (–) key.
Setting range: –95 – +95
Initial setting: 0
Changing the value by 1 changes
No
the amount of slack by 0.32 mm.
The greater the value,
the larger the amount of slack;
the smaller the value, the smaller
the amount of slack.
End
Original
example 1
Figure 1-6-28
Press the start key.
The new setting is stored.
Increase the value using the zoom (+) key.
Copy Copy
example 2