Adjusting The Df Magnification - Kyocera Mita KM-1810 Service Manual

(4) Adjusting the DF magnification

Adjust magnification in the auxiliary scanning direction if magnification is incorrect when the DF is used.
U053 U065
(P. 1-4-10) (P. 1-6-28)
Caution:
Before making the following adjustment, ensure that the above adjustments have been made in maintenance mode.
Procedure
Enter maintenance mode.
Enter "070" using the copy exposure
adjustment keys or zoom +/- keys.
Press the start key.
Press the printer key and the machine
enters the test copy mode.
Place an original on the DF
and make a test copy.
Is the image correct?
Press the stop/reset key
to exit maintenance mode.
U070
Start
No
Yes
End
Main scanning
direction
Auxiliary
scanning
direction
Original
Figure 1-6-89
Press the start key.
The new setting is stored.
Change the setting.
• For copy example 1, increase
the value using the zoom (+)
key to make the copy image
longer.
• For copy example 2, decrease
the value using the zoom (-)
keys to make the copy image
shorter.
Setting range: –25 – +25
Initial setting: 0
Changing the value by 1 changes
the magnification by 0.1%.
Increase the value makes
the image longer, and decreasing it
make the image shorter.
Copy Copy
example 1 example 2
1-6-49
2A1/2