2A1/2
(3) Adjusting the DF lateral squareness
Perform the following adjustment if the copy image is laterally skewed (lateral squareness not obtained) when the DF is
used.
Procedure
Place an original on the DF
and make a test copy.
Is the image correct?
1-6-48
Start
Open the DF, loosen the screw
and adjust the position of the
DF.
• For copy example 1, move the
No
• For copy example 2, move the
Yes
End
Retighten the screw and
close the DF.
DF in the direction of the black
arrow ( ).
DF in the direction of the white
arrow ( ).
Copy
Original
example 1
Figure 1-6-87
Screw
Figure 1-6-88
Copy
example 2