Adjusting The Positions Of The Front Side Registration Cursor, Rear Side Registration Cursor And Trailing Edge Registration Cursor (Reference) - Kyocera Mita KM-3530 Service Manual

3B5
(2) Adjusting the positions of the front side registration cursor, rear side registration cursor and trailing edge
registration cursor (reference)
Perform the following adjustment if paper registration is poor or stapling is made outside the specified area.
Procedure
Start
Make a test copy
in staple-sort mode.
Is the paper registration
good?
Is the stapling
position correct?
See Figure 1-4-1.
End
1-4-2
No
Yes
No
Yes
Enter maintenance mode.
Enter "246" using the numeric
keys.
Press the start key.
Select the item to be adjusted .
Change the setting using the
cursor up/down keys.
Press the start key.
Press the stop/clear key.
Exit maintenance mode.
Rear side
registration cursor
ADJUST FRONT JOGGER: Stop position of the
front side registration cursor
ADJUST REAR JOGGER: Stop position of the rear
side registration cursor
ADJUST END JOGGER: Stop position of the
trailing edge registration cursor
Setting range: 0 to 8
The new setting
Reference: 4
is stored.
Changing the value by 1 changes the position by
0.5 mm.
Increasing the value moves the front or rear side
registration cursor or trailing edge registration
cursor outward (a); decreasing the value moves
each cursor inward (e). See Figure 1-4-2.
Figure 1-4-2
Stapler
5 ± 3.0 mm
5 ± 3.0 mm
Figure 1-4-1 Stapling position
Trailing edge
registration cursor
Front side
registration cursor