Paper Feed Section; Detaching And Refitting The Paper Feed Pulleys - Kyocera Mita KM-1810 Service Manual

1-6-2 Paper feed section

(1) Detaching and refitting the paper feed pulleys

Follow the procedure below to replace the paper feed pulleys.
Procedure
1. Remove the printer cover and rear cover. Pull
out the drawer.
2. Remove the four screws and then detach the
high-voltage transfer PCB.
3. Remove the stop ring and then the paper
feed clutch.
4. Remove the stop ring snd bushing from the
paper feed shaft unit.
High-voltage transfer PCB
Figure 1-6-1
Stop ring
Paper feed clutch
Figure 1-6-2
Stop ring
Bushing
Figure 1-6-3
2A1/2
1-6-3