Adjusting The Margins For Printing - Kyocera Mita KM-1810 Service Manual

(4-4) Adjusting the margins for printing

Make the following adjustment if the margins are not correct.
U403
U402
(P. 1-6-31)
Caution:
Check the copy image after the adjustment. If the margins are still incorrect, perform the above adjustments in
maintenance mode.
Procedure
Enter maintenance mode.
Enter "402" using the copy exposure
adjustment keys or zoom +/- keys.
Press the start key.
Select the item to be adjusted using
the copy exposure adjustment keys.
Exp. 1 (lit): Printer leading edge margin
Exp. 3 (lit): Printer left/right margins
Exp. 5 (lit): Printer trailing edge margin
Exp. 1 (flashing): Printer trailing edge
margin of non-standard size from
the drawer*
Exp. 3 (flashing): Printer trailing edge
margin of non-standard size from
the bypass tray*
Press the printer key and the machine
enters the test copy mode.
Press the start key
to output a test pattern.
Are the margins correct?
Yes
Press the stop/reset key to
exit maintenance mode.
U404
(P. 1-6-53)
Start
No
Yes
Proceed to
another mode?
No
End
Ejection direction
(reference)
Printer
left margin
+2.0
(2.0 mm)
–1.5
Figure 1-6-27
* Amount of image loss (msec)
after the registration switch turns off
Press the start key.
The new setting is stored.
Change the setting.
Increasing the value using the zoom (+)
key makes the margin wider.
Decreasing the value using the zoom (–)
key makes the margin narrower.
Setting range (initial setting/change in value per step)
Printer leading edge margins: 0 – +10 (3/0.5 mm)
Printer left/right margin: –5 – +10 (2.5/0.5 mm)
Printer trailing edge margin: –5 – +10 (4.5/0.5 mm)
Printer trailing edge margin of non-standard size
from the drawer: 0 – +400 (214/1 msec)
Printer trailing edge margin of non-standard size
from the bypass tray: 0 – +400 (200/1 msec)
Printer leading edge margin
(3 2.5 mm)
Printer
right margin
+2.0
(2.0 mm)
–1.5
Printer trailing edge margin
(3 2.5 mm)
1-6-15
2A1/2