Fixing Section; Detaching And Refitting The Fixing Unit; Detaching And Refitting The Fixing Unit Thermistor - Kyocera Mita KM-1810 Service Manual

1-6-6 Fixing section

(1) Detaching and refitting the fixing unit

Follow the procedure below to check or replace the fixing unit.
Procedure
1. Open the paper conveying unit and remove
the left cover.
2. Remove the two screws and detach the three
connector and then remove the fixing unit.

(2) Detaching and refitting the fixing unit thermistor

Follow the procedure below to replace the fixing unit thermistor.
Procedure
1. Remove the fixing unit.
2. Remove the screw and then remove the
fixing unit thermistor.
3. Replace the fixing unit thermistor and refit all
the removed parts.
Connectors
Figure 1-6-67
Connector
Fixing unit
Fixing unit thermistor
Figure 1-6-68
2A1/2
1-6-39