Detaching And Refitting The Bypass Paper Feed Pulley - Kyocera Mita KM-1810 Service Manual

(3) Detaching and refitting the bypass paper feed pulley

Follow the procedure below to replace the bypass paper feed pulley.
Procedure
1. Remove the printer cover, rear cover and left
cover.
2. Remove the image formation unit (see page
1-6-32).
3. Remove the fixing unit (see page 1-6-39).
4. Remove the screw and then the fulcrum pin.
5. Remove the paper conveying unit.
6. Remove the three screws holding the bypass
cover and then the cover.
Fulcrum pin
Figure 1-6-17
Paper conveying unit
Figure 1-6-18
Figure 1-6-19
2A1/2
Bypass cover
1-6-9