Adjusting The Center Line Of Image Printing - Kyocera Mita KM-1810 Service Manual

2A1/2

(4-3) Adjusting the center line of image printing

Make the following adjustment if there is a regular error between the center lines of the copy image and original when
paper is fed from the drawer.
U067
U034
(P. 1-6-30)
Caution:
Check the copy image after the adjustment. If the image is still incorrect, perform the above adjustments in maintenance
mode.
Procedure
Enter maintenance mode.
Enter "034" using the copy exposure
adjustment keys or zoom +/- keys.
Select the item to be adjusted using
the copy exposure adjustment keys.
Exp. 5 (lit): Center line from the drawer
Exp. 1 (flashing): Center line from
the bypass tray
to output a test pattern.
Press the stop/reset key to exit
1-6-PB
U072
(P. 1-6-52)
Start
Press the start key.
Press the interrupt key.
Press the start key
Is the image correct?
Yes
maintenance mode.
End
Center line of printing
Correct image
Figure 1-6-26
Press the start key.
The new setting is stored.
For output example 1, decrease
No
the value using the zoom (–) key.
For output example 2, increase
the value using the zoom (+) key.
Setting range: –5.0 – +5.0
Initial setting: 0
Changing the value by 1 moves the
center line by 1 mm.
Output Output
example 1 example 2