3CX
1-4-2 Procedure for assembly and disassembly
(1) Adjusting the margin for printing
Perform the following adjustment if the printer leading edge margin for duplex copying (second face) is not correct.
Procedure
Start
Enter maintenance mode.
Enter "402" using the numeric
keys.
Press the start key.
Select "TRAIL (DUP)".
Press the interrupt key.
Press the start key to
output a test pattern.
Is the margin correct?
Yes
Press the stop/clear key
to exit maintenance mode.
End
1-4-2
Press the start key.
The new setting is stored.
No
Change the value using the
cursor up/down keys.
Setting range: –5.0 to +10.0
Reference: 4.5
Changing the value by 1 moves the margin by
0.5 mm.
Increasing the value makes the margin wider
and decreasing it makes the margin narrower.
Printer leading edge margin
for duplex copying
(second face, 3 ± 2.5 mm)
Figure 1-4-1