Adjusting The Margins For Printing - Kyocera Mita KM-1530 Service Manual

(6-4) Adjusting the margins for printing

Make the following adjustment if the margins are not correct.
U403
U402
(P. 1-6-38)
Caution:
Check the copy image after the adjustment. If the margins are still incorrect, perform the above adjustments in
maintenance mode.
Procedure
• 20 cpm
Start
Enter maintenance mode.
Enter "402" using the numeric keys.
Press the start key.
Select the items to be adjusted using
the cursor up/down keys.
Press the interrupt key.
Press the start key to output a test
pattern using A3/11" × 17" paper.
Are the margins correct?
Yes
Proceed to
another mode?
Press the stop/clear key to
exit maintenance mode.
End
U404
(P. 1-4-46)
LEAD : printer leading edge margin
AC : printer left/right margins
TRAIL : printer trailing edge margin
D CUT : printer trailing edge margin
TRAIL2 : printer trailing edge margin for
Press the start key.
Change the setting.
Increasing the value using the cursor right
No
key makes the margin winder.
Decreasing the value using the cursor left
key makes the margin narrower.
Yes
Setting range (initial setting/change in value per step)
Printer leading edge margin: 0 – +10 (3/0.5 mm)
Printer left/right margin: –5 – +10 (2.5/0.5 mm)
Printer trailing edge margin (standard size): –5 – +10 (4.5/0.5 mm)
Printer trailing edge margin (non-standard size): –5 – +5 (3/0.25 mm)
Printer trailing edge margin for duplex copying
No
(second face): –5 – +10 (4.5/0.5 mm)
Printer leading edge margin
(3 ± 2.5 mm)
Printer
left margin
+2.0
(2.5 mm)
–1.5
Printer trailing edge margin
(3 ± 2.5 mm)
Normal copy mode
(A3/11" × 17")
(standard size)
(non-standard size)
duplex copying (second face)
The new setting is stored.
Ejection direction
(reference)
Printer
right margin
+2.0
(2.5 mm)
–1.5
2AV/X
Printer trailing edge margin
(3 ± 2.5 mm)
for duplex copying
Duplex copy mode
(second face, A3/11" × 17")
1-6-15
1-6