Adjusting The Center Line Of Image Printing - Kyocera Mita KM-3530 Service Manual

3CX

(3) Adjusting the center line of image printing

Make the following adjustment if there is a regular error between the center lines of the copy image and original when
copying using the duplex unit.
Procedure
Start
Enter maintenance mode.
Enter "034" using
the numeric keys.
Press the start key.
Select "LSU OUT (DUP)".
Press the interrupt key.
Press the start key to
output a test pattern.
Is the image correct?
Press the stop/clear key
to exit maintenance mode.
End
1-4-4
For output example 1, decrease
the value using the cursor down
No
key.
For output example 2, increase
the value using the cursor up key.
Yes
Setting range: –5.0 to +5.0
Changing the value by 1 moves the
center line by 1.0 mm.
Initial setting: 0
Center line of printing
Correct image
Press the start key.
The new setting is stored.
Output Output
example 1 example 2
Figure 1-4-3