Adjusting The Center Line Of Image Printing - Kyocera Mita KM-1530 Service Manual

(6-3) Adjusting the center line of image printing

Make the following adjustment if there is a regular error between the center lines of the copy image and original when
paper is fed from the drawer.
U067
U034
(P. 1-6-37)
Caution:
Check the copy image after the adjustment. If the image is still incorrect, perform the above adjustments in maintenance
mode.
Procedure
• 20 cpm
Start
Enter maintenance mode.
Enter "034" using the numeric keys.
Press the start key.
Select "Adjusting the center line"
and press the start key.
Select the item to be adjusted using
the cursor up/down keys.
Press the interrupt key.
Press the start key to output a test
pattern.
Is the image correct?
Yes
Press the stop/clear key to exit
maintenance mode.
End
U072
(P. 1-4-15)
LSU DECK : Upper drawer
LSU BYP : Bypass tray
LSU 2ND : Lower drawer
LSU 3RD : Optional drawer 1
LSU 4TH : Optional drawer 2
LSU DUP : Duplex copying (second face)
Press the start key.
The new setting is stored.
For output example 1, decrease
No the value using the cursor left key.
For output example 2, increase
the value using the cursor right key.
Setting range: –5.0 – +5.0
Initial setting: 0
Changing the value by 1 moves the
center line by 1 mm.
Center line of printing
Correct image Output
example 1
Figure 1-6-21a
2AV/X
Output
example 2
1-6-13
1-6