Inserting The Flue Gas Baffle Plates; Fitting Burner Door Panel - Buderus Logano G315 Installation And Service Instructions Manual

7
Boiler block assembly
7.8.3

Inserting the flue gas baffle plates

In pre-assembled boilers, the flue gas baffles
are already fitted
B Remove the cardboard transport
protectors from the pre-assembled boiler.
B Take flue gas baffles from the crate and insert into the
flue gas passages as indicated by their inscription
( Fig. 30 and Tab. 10).
Fig. 30 Flue gas baffle plates
Number
of flue
Number gas
of boiler baffle
sections plates
5 4
6 – 7 4
8 4
9 4
Tab. 10
28
Length of Installation
flue gas directions on
baffle plate the flue gas
in inches baffle plate
(mm) ( Fig. 30)
14-11/64
(360)
top right
17-21/64
top left
(440)
bottom right
14-11/64
bottom left
(360)
7-7/8 (200)
7.8.4

Fitting burner door panel

In the factory, the burner door is mounted with the hinges
on the right hand side (Fig. 31, [4 and 6]). For left-hand
closing, remove the hinges accordingly on the left-hand
side of the burner door.
B Screw the hinge pins (Fig. 31. [1 and 3]) to the front
boiler section with 2 M 12 x 50 machine screws in
each case. This is shown in Fig. 31 for the right-hand
closing version. For left-hand closing, secure hinge
pins accordingly on the left-hand side.
B Affix Ø 18 mm diameter GP cord in the front section
using adhesive. The sealant rope joint should be
located at the side (Fig. 31, [2]).
B Hook the burner door with the hinge lobes into the
hinge pins.
Fig. 31 Hooking in the burner door
Logano G315 - Subject to technical modifications