7
Assembling the boiler block
7.4.2 Inserting the hot gas baffle plates
Remove the corrugated cardboard packaging when
the block is supplied ready assembled.
When the boiler is supplied in sections, remove the
hot gas baffle plates from the cardboard box
containing the fittings.
Insert the hot gas baffle into the central second hot
gas flue in accordance with the table below. The cast
lugs should point towards the centre of the boiler.
Insert the hot gas baffle into the third hot gas flue in
accordance with the table below. The cast lugs
should point outwards.
Boiler rating
Boiler size incl. oil burner
2. hot gas flue
top
centre
bottom
3. hot gas flue
Tab. 12 Hot gas baffle plate arrangement
By removing the hot gas baffle, you can raise the flue
gas temperature (
Section 9.4.1, page 44).
7.4.3 Installing the burner door
You can fit the burner door on the right-hand or on the
left-hand side. In the following points, assembly on the
right-hand side is described.
Secure the two hinge pins to the front section using
one M12 × 35 hexagon bolt for each.
28
52
64
78
95
4
5
6
7
–
–
–
–
–
2
–
–
–
2
–
–
2
–
–
–
Logano G215 WS - We reserve the right to make any changes due to technical modifications.
Fig. 30 Inserting the hot gas baffle into the second hot gas
flue (here: centrally)
Fig. 31 Insert the hot gas baffle into the third hot gas flue
Fig. 32 Fitting the hinge pins (here: on the right-hand side)
1 M12 × 35 hexagon bolt
1
1