Show Mls Qos Interface - Cisco Catalyst 3750-X Command Reference Manual

show mls qos interface

show mls qos interface
Use the show mls qos interface user EXEC command to display quality of service (QoS) information
at the port level.
Syntax Description interface-id
buffers
queueing
statistics
Though visible in the command-line help string, the policers keyword is not supported.
Note
Command Modes User EXEC
Command History Release
12.2(53)SE2
Examples This is an example of output from the show mls qos interface interface-id command when VLAN-based
QoS is enabled:
Switch> show mls qos interface gigabitethernet1/0/1
GigabitEthernet1/0/1
trust state:not trusted
trust mode:not trusted
trust enabled flag:ena
COS override:dis
default COS:0
DSCP Mutation Map:Default DSCP Mutation Map
Trust device:none
qos mode:vlan-based
Catalyst 3750-X and 3560-X Switch Command Reference
2-760
show mls qos interface [interface-id] [buffers | queueing | statistics]
(Optional) Display QoS information for the specified port. Valid interfaces
include physical ports.
(Optional) Display the buffer allocation among the queues.
(Optional) Display the queueing strategy (shared or shaped) and the weights
corresponding to the queues.
(Optional) Display statistics for sent and received Differentiated Services Code
Points (DSCPs) and class of service (CoS) values, the number of packets
enqueued or dropped per egress queue, and the number of in-profile and
out-of-profile packets for each policer.
Modification
This command was introduced.
Chapter 2 Catalyst 3750-X and 3560-X Switch Cisco IOS Commands
OL-29704-01