Stack-Power - Cisco Catalyst 3750-X Command Reference Manual

stack-power

stack-power
To configure StackPower parameters for the power stack or for a switch in the power stack, use the stack
power global configuration command. To return to the default setting, use the no form of the command,
This command is available only on Catalyst 3750-X switch stacks running the IP base or IP services
Note
image.
Syntax Description
stack power stack name Enter the power stack name. The name can be up to 31 characters. Entering
switch switch-number
Defaults
There is no default.
Command Modes
Global configuration
Command History Release
12.2(53)SE2
Usage Guidelines
When you enter the stack-power stack power stack name command, you enter power stack
configuration mode, and these commands are available:
•
•
•
•
If you enter the stack-power switch switch-number command with a switch number that is not
participating in stack power, you receive an error message.
When you enter the stack-power switch switch-number command with the number of a switch
participating in stack power, you enter switch stack power configuration mode, and these commands are
available:
•
•
•
Catalyst 3750-X and 3560-X Switch Command Reference
2-908
stack-power {stack power stack name | switch switch-number}
no stack-power {stack-id name | switch switch-number}
these keywords followed by a carriage return puts you in power stack
configuration mode.
Enter the switch number in the stack (1 to 4) to enter switch stack-power
configuration mode for the switch.
Modification
This command was introduced.
default: returns a command to its default setting.
exit: exits ARP access-list configuration mode.
mode: sets the power mode for the power stack. See the
no: negates a command or returns to default settings.
default: returns a command to its default setting.
exit: exits switch stack power configuration mode.
no: negates a command or returns to default settings.
Chapter 2 Catalyst 3750-X and 3560-X Switch Cisco IOS Commands
mode command.
OL-29704-01