Appendix B
Catalyst 3750-X and 3560-X Switch Debug Commands
debug platform frontend-controller
Use the debug platform frontend-controller privileged EXEC command to enable debugging of
front-end controller activity. Use the no form of this command to disable debugging.
Syntax Description
all
image
led
manager
poe
register
thermal
Defaults
Debugging is disabled.
Command Modes
Privileged EXEC
Command History
Release
12.2(53)SE2
Usage Guidelines
The undebug platform frontend-controller command is the same as the no debug platform
frontend-controller command.
When you enable debugging on a switch stack, it is enabled only on the stack master. To enable
debugging on a stack member, you can start a session from the stack master by using the session
switch-number privileged EXEC command. Then enter the debug command at the command-line
prompt of the stack member. You also can use the remote command stack-member-number LINE
privileged EXEC command on the stack master switch to enable debugging on a member switch without
first starting a session.
Related Commands
Command
show platform
frontend-controller
show debugging
OL-29704-01
debug platform frontend-controller {all | image | led | manager | poe | register | thermal}
no debug platform frontend-controller {all | image | led | manager | poe | register | thermal}
Display all the debug messages for front-end controller.
Display Image Manager debug messages.
Display LED debug messages.
Display front-end-controller manager debug messages.
Display Power over Ethernet (PoE) debug messages.
Display Register Access debug messages.
Display thermal debug messages.
Modification
This command was introduced.
Description
Displays counter and status information for the front-end controller
manager and subordinate applications, and displays the hardware and
software information for the front-end controller.
Displays information about the types of debugging that are enabled.
debug platform frontend-controller
Catalyst 3750-X and 3560-X Switch Command Reference
B-51