Cisco Catalyst 3750-X Command Reference Manual page 848

show switch service-modules
This is an example of output when a switch with a service module installed is running the LAN base
feature set and service-module-specific features are not supported:
Switch# show switch service-modules
Switch/Stack supports service module CPU version: 03.00.25
Switch#
-----------------------------------------------------------------
1
* Module services not supported on a Lanbase license
Table 2-50
Field
Switch
H/W Status
Temperature
(CPU/FPGA)
CPU Link
CPU Version
Catalyst 3750-X and 3560-X Switch Command Reference
2-816
Temperature
H/W Status (CPU/FPGA)
LB-PASS-THRU * 71C/59C
show switch service-modules Command Output
Description
The switch number in the stack. For a standalone switch, this number is
always 1.
OK—The service module is operating and all features are supported.
•
POWER-BAD—The service module is experiencing a hardware failure.
•
FPGA-NOBOOT—There is a hardware failure related to the service
•
module FPGA.
CPU-NOBOOT—There is a hardware failure related to the service
•
module CPU.
SWITCH-HW-REV—The hardware version of the switch is not new
•
enough to support the service module. The service module runs in
pass-through mode.
LB-PASS-THRU—The switch is running the LAN base feature set,
•
which does not support the service module, so the mode is pass-through.
Temperature (Centigrade) of the service module CPU and the service module
FPGA.
connected—The service module is operating, and
•
service-module-specific features are available on the SFP module ports.
notconnected—The service module is not operational. The ports are
•
operating in pass-through mode and supporting only standard switch
features.
The software version of the service module.
Chapter 2 Catalyst 3750-X and 3560-X Switch Cisco IOS Commands
CPU
CPU Link Version
notconnected N/A
OL-29704-01