Ip Igmp Snooping Vlan Mrouter - Cisco Catalyst 3750-X Command Reference Manual

ip igmp snooping vlan mrouter

ip igmp snooping vlan mrouter
Use the ip igmp snooping mrouter global configuration command on the switch stack or on a
standalone switch to add a multicast router port or to configure the multicast learning method. Use the
no form of this command to return to the default settings.
Syntax Description
vlan-id
interface interface-id
learn {cgmp |
pim-dvmrp}
Defaults By default, there are no multicast router ports.
The default learning method is pim-dvmrp—to snoop IGMP queries and PIM-DVMRP packets.
Command Modes Global configuration
Command History Release
12.2(53)SE2
Usage Guidelines VLAN IDs 1002 to 1005 are reserved for Token Ring and FDDI VLANs and cannot be used in IGMP
snooping.
The CGMP learn method is useful for reducing control traffic.
The configuration is saved in NVRAM.
Catalyst 3750-X and 3560-X Switch Command Reference
2-298
ip igmp snooping vlan vlan-id mrouter {interface interface-id | learn {cgmp | pim-dvmrp}}
no ip igmp snooping vlan vlan-id mrouter {interface interface-id | learn {cgmp | pim-dvmrp}}
Enable IGMP snooping, and add the port in the specified VLAN as the
multicast router port. The range is 1 to 1001 and 1006 to 4094.
Specify the next-hop interface to the multicast router. The keywords have
these meanings:
•
•
•
Specify the multicast router learning method. The keywords have these
meanings:
•
•
Modification
This command was introduced.
Chapter 2
gigabitethernet interface number—a Gigabit Ethernet IEEE 802.3z
interface.
tengigabitethernet interface number—a 10-Gigabit Ethernet
IEEE 802.3z interface.
port-channel interface number—a channel interface. The range is 0
to 48.
cgmp—Set the switch to learn multicast router ports by snooping on
Cisco Group Management Protocol (CGMP) packets.
pim-dvmrp—Set the switch to learn multicast router ports by snooping
on IGMP queries and Protocol-Independent Multicast-Distance Vector
Multicast Routing Protocol (PIM-DVMRP) packets.
Catalyst 3750-X and 3560-X Switch Cisco IOS Commands
OL-29704-01