Cisco Catalyst 3750-X Command Reference Manual page 680

show interfaces
backup
tengigabitethernet
transceiver [detail |
properties |
dom-supported-list]
trunk
Note Though visible in the command-line help strings, the crb, fair-queue, irb, mac-accounting,
precedence, random-detect, rate-limit, and shape keywords are not supported.
Command Modes Privileged EXEC
Command History Release
12.2(53)SE2
Usage Guidelines The show interfaces capabilities command with different keywords has these results:
•
•
•
•
•
•
•
Examples This is an example of output from the show interfaces command for an interface on stack member 3:
Switch# show interfaces gigabitethernet3/0/2
GigabitEthernet3/0/2 is down, line protocol is down
Hardware is Gigabit Ethernet, address is 0009.43a7.d085 (bia 0009.43a7.d085)
MTU 1500 bytes, BW 10000 Kbit, DLY 1000 usec,
Catalyst 3750-X and 3560-X Switch Command Reference
2-648
(Optional) Display Flex Link backup interface configuration and status for
the specified interface or all interfaces on the switch or the stack.
Display the status of a connected ten-gigabit module.
See the
Display interface trunk information. If you do not specify an interface, only
information for active trunking ports appears.
Modification
This command was introduced.
On Catalyst 3750-X switches, use the show interface capabilities module number command to
display the capabilities of all interfaces on that switch in the stack. If there is no switch with that
module number in the stack, there is no output.
On Catalyst 3560-X switches, use the show interface capabilities module 1 command to display
the capabilities of all interfaces on the switch. Any other number is invalid.
Use the show interfaces interface-id capabilities to display the capabilities of the specified
interface.
On Catalyst 3750-X switches, use the show interfaces capabilities (with no module number or
interface ID) to display the capabilities of all interfaces in the stack.
On Catalyst 3560-X switches, use the show interfaces capabilities (with no module number or
interface ID) to display the capabilities of all interfaces on the switch.
On Catalyst 3750-X switches, use the show interface switchport module number command to
display the switch port characteristics of all interfaces on that switch in the stack. If there is no
switch with that module number in the stack, there is no output.
On Catalyst 3560-X switches, use the show interface switchport module 1 to display the switch
port characteristics of all interfaces on the switch. Any other number is invalid.
reliability 255/255, txload 1/255, rxload 1/255
Chapter 2 Catalyst 3750-X and 3560-X Switch Cisco IOS Commands
show interfaces transceivers command.
OL-29704-01