Vtp (Interface Configuration) - Cisco Catalyst 3750-X Command Reference Manual

vtp (interface configuration)

vtp (interface configuration)
Use the vtp interface configuration command to enable the VLAN Trunking Protocol (VTP) on a
per-port basis. Use the no form of this command to disable VTP on the interface.
This command is supported only when the switch is running VTP version 3.
Note
Syntax Description
This command has no keywords or arguments.
Command Default This command has no default settings.
Command Modes Interface configuration.
Command History Release
12.2(53)SE2
Usage Guidelines Enter this command only interfaces that are switchport in trunk mode.
This command is supported only on switches configured for VTP version 3.
Examples This example shows how to enable VTP on an interface:
Switch(config-if)# vtp
This example shows how to disable VTP on an interface:
Switch(config-if)# no vtp
Related Commands Command
vtp (global
configuration)
Catalyst 3750-X and 3560-X Switch Command Reference
2-998
vtp
no vtp
Modification
This command was introduced.
Description
Globally configures VTP domain-name, password, pruning, version, and
mode.
Chapter 2 Catalyst 3750-X and 3560-X Switch Cisco IOS Commands
OL-29704-01