Cisco Catalyst 3750-X Command Reference Manual page 741

Chapter 2 Catalyst 3750-X and 3560-X Switch Cisco IOS Commands
Table 2-38
Field
LACPDUs Sent and Recv
Marker Sent and Recv
Marker Response Sent and Recv
LACPDUs Pkts and Err
This is an example of output from the show lacp internal command:
Switch> show lacp 1 internal
Flags:
Channel group 1
Port
Gi2/0/1
Gi2/0/2
Table 2-39
Table 2-39 show lacp internal Field Descriptions
Field
State
LACP Port Priority
Admin Key
Oper Key
OL-29704-01
show lacp counters Field Descriptions
S - Device is requesting Slow LACPDUs
F - Device is requesting Fast LACPDUs
A - Device is in Active mode
LACP port
Flags State Priority
SA bndl
SA bndl
describes the fields in the display:
Description
State of the specific port. These are the allowed values:
– —Port is in an unknown state.
•
bndl—Port is attached to an aggregator and bundled with other ports.
•
susp—Port is in a suspended state; it is not attached to any aggregator.
•
hot-sby—Port is in a hot-standby state.
•
indiv—Port is incapable of bundling with any other port.
•
indep—Port is in an independent state (not bundled but able to switch data traffic. In this
•
case, LACP is not running on the partner port).
down—Port is down.
•
Port priority setting. LACP uses the port priority to put ports s in standby mode when there is
a hardware limitation that prevents all compatible ports from aggregating.
Administrative key assigned to this port. LACP automatically generates an administrative key
value as a hexadecimal number. The administrative key defines the ability of a port to
aggregate with other ports. A port's ability to aggregate with other ports is determined by the
port physical characteristics (for example, data rate and duplex capability) and configuration
restrictions that you establish.
Runtime operational key that is being used by this port. LACP automatically generates this
value as a hexadecimal number.
Description
The number of LACP packets sent and received by a port.
The number of LACP marker packets sent and received by a port.
The number of LACP marker response packets sent and received
by a port.
The number of unknown and illegal packets received by LACP
for a port.
P - Device is in Passive mode
Admin
Key
32768 0x3
32768 0x3
Catalyst 3750-X and 3560-X Switch Command Reference
Oper Port Port
Key Number State
0x3 0x4 0x3D
0x3 0x5 0x3D
show lacp
2-709