Configure Radius Server Settings - NETGEAR ProSafe Premium WNDAP660 Reference Manual

ProSafe Premium 3 x 3 Dual-Band Wireless-N Access Point WNDAP660
• WPA-PSK & WPA2-PSK
Figure 29.
Table 13. Settings for WPA-PSK, WPA2-PSK, and WPA-PSK & WPA2-PSK
Setting Descriptions
Data Encryption TKIP
AES
TKIP + AES TKIP + AES supports both WPA and WPA2. Broadcast packets use TKIP. For
Passphrase Enter a passphrase. The passphrase length needs to be between 8 and 63 characters
(inclusive). The default passphrase is sharedsecret.
You can display the actual passphrase by selecting the Show Passphrase in Clear Text
Yes radio button.
Show Passphrase Select the Yes radio button to display the actual passphrase in the Passphrase field. The
in Clear Text default setting is No.

Configure RADIUS Server Settings

For authentication, accounting, or both authentication and accounting using RADIUS, you
need to configure primary servers and optional secondary servers. These RADIUS server
settings can apply to all devices that are connected to the wireless access point.
You can configure both IPv4 and IPv6 servers. In the IPv4 Radius Server Settings section,
enter IPv4 addresses only; in the IPv6 Radius Server Settings section, enter IPv6 addresses
only.
Temporal Key Integrity Protocol (TKIP) is the standard encryption method
used with WPA. You can also use TKIP with WPA2.
Note: TKIP provides only legacy (slower) rates of operation. NETGEAR
recommends WPA2 authentication with AES encryption if you want to use the
11n rates and speed.
Advanced Encryption Standard (AES) is the standard encryption method used
with WPA2.
Note: Although some wireless clients might support AES with WPA, the
WNDAP660 wireless access point does not support WPA with AES.
unicast (point-to-point) transmissions, WPA clients use TKIP, and WPA2
clients use AES.
For the WPA & WPA2 mixed mode, TKIP + AES is the only supported data
encryption method.
Wireless Configuration and Security
57