NETGEAR ProSafe Premium WNDAP660 Reference Manual page 129

ProSafe Premium 3 x 3 Dual-Band Wireless-N Access Point WNDAP660
Figure 75.
g. Specify the settings as explained in the following table:
Table 38. Wireless signal repeating profile and authentication settings
Setting
Profile Definition
Profile Name
Remote MAC Address
Authentication Settings
Network Authentication
and
Data Encryption
Description
Enter a profile name that is easy to remember. The default names for the four
security profiles are NETGEAR-WDS-1, NETGEAR-WDS-2,
NETGEAR-WDS-3, and NETGEAR-WDS-4.
Enter the MAC address of the remote wireless access point (the MAC
address of AP1 or AP3 in Figure 73
From the Network Authentication drop-down list, select Open System,
WPA-PSK, or WPA2-PSK. Your selection determines the options that the
Data Encryption drop-down list provides, and whether the WPA Passphrase
(Network Key) field displays.
Open System Although you can use the bridge communication without any
authentication and encryption, NETGEAR recommends that
you use WEP if you do select an open system. From the
Data Encryption drop-down list, select one of the following:
• None. No authentication and encryption.
• 64-bit WEP. Standard WEP encryption, using 40/64-bit
encryption.
• 128-bit WEP. Standard WEP encryption, using
104/128-bit encryption.
• 152-bit WEP. Proprietary WEP encryption mode, using
128+24 bit encryption. This mode functions only with
other wireless stations that support this mode.
Advanced Configuration
129
on page 127).