Factory Default Settings - NETGEAR ProSafe Premium WNDAP660 Reference Manual

ProSafe Premium 3 x 3 Dual-Band Wireless-N Access Point WNDAP660

Factory Default Settings

You can use the Reset button located on the rear of the wireless access point to reset all
settings to their factory defaults. This is called a hard reset.
To perform a hard reset, use a sharp object to press and hold the Reset button for
approximately 5 seconds (until the Test LED blinks rapidly). This returns the wireless access
point to the factory configuration settings that are shown in the following table.
Note: Pressing the Reset button for a shorter period of time simply causes
the wireless access point to reboot.
Table 40. Default configuration settings
Feature
Login for management and configuration
LAN IPv4 management address
Subnet mask for IPv4 management address
LAN IPv6 management address
Prefix length for IPv6 management address
Required static IPv4 address for management
computer
User name (case-sensitive) for login
Login password (case-sensitive) for login
LAN and management features
DHCPv4 client
DHCPv6 client
Untagged VLAN
Management VLAN
SNMP
Syslog
Spanning Tree Protocol (STP)
Link Layer Discovery Protocol (LLDP)
Secure Shell (SSH)
Description
192.168.0.100
255.255.255.0
2001::21c:c0ff:fe69
64
192.168.0.210 and 255.255.255.0
admin
password
Disabled
Disabled
Enabled, VLAN ID 1
VLAN ID 1
Disabled
Disabled
Disabled
Enabled
Enabled
Supplemental Information
143