Configure The Optional Dhcpv6 Server - NETGEAR ProSafe Premium WNDAP660 Reference Manual

ProSafe Premium 3 x 3 Dual-Band Wireless-N Access Point WNDAP660
Table 28. IPv6 settings (continued)
Setting
Default Gateway
Dynamic IPv6 Address
Primary DNS Server
Secondary DNS Server
Network Integrity Check
3. Click Apply to save your settings.

Configure the Optional DHCPv6 Server

The wireless access point provides a built-in DHCPv6 server for wireless clients only, which
can be especially useful in small networks. When the DHCP server is enabled, the wireless
access point provides preconfigured TCP/IP configurations to all connected wireless stations.
Note: For information about how to configure the DHCPv4 server, see
Configure the Optional DHCPv4 Server

To configure DHCPv6 server settings:
1. Select Configuration > IP > DHCP Server Settings. The DHCP Server Settings screen
displays. The following figure displays the DHCPv6 server settings only. For information
about the DHCPv6 server settings, see
page 27.
Description
Enter the IPv6 address of the ISP gateway to which the wireless access point
connects.
The dynamic IPv6 address that is assigned by the DHCPv6 server on your
network. This address does not overwrite the address in the IPv6 Address field.
Enter the IP address of the primary and secondary DNS servers.
A DNS server is a host on the Internet that translates Internet names (such as
www.netgear.com) to numeric IP addresses. Typically your ISP transfers the IP
address of one or two DNS servers to your wireless access point during login. If
the ISP does not transfer an address, you need to obtain it from the ISP and
enter it manually in this field.
Select this check box to validate that the upstream link is active before allowing
wireless associations. Ensure that the default gateway is configured.
Configure the Optional DHCPv4 Server
Advanced Configuration
101
on page 27.
on