NETGEAR ProSafe Premium WNDAP660 Reference Manual page 130

ProSafe Premium 3 x 3 Dual-Band Wireless-N Access Point WNDAP660
Table 38. Wireless signal repeating profile and authentication settings (continued)
Setting
Network Authentication
and
Data Encryption
(continued)
h. Click Apply to save your security profile settings. The Bridging screen displays
again.
i. Repeat Step e
For example, first configure security profile NETGEAR-WDS-1 with the MAC address
of AP1, and then configure security profile NETGEAR-WDS-2 with the MAC address
of AP3 (see Figure 73
2. Activate repeater mode on the wireless access point (AP2 in
a. On the Bridging screen, select the Enable Wireless Bridging check box.
b. Select the Wireless Point-to-Multi-Point Bridge radio button.
c. Clear the Enable Wireless Client Association check box to disable wireless client
association (see the red circle in
Note: If you do not clear the Enable Wireless Client Association check box,
the wireless access point functions in regular point-to-multipoint
bridge mode.
d. If the correct profile names and security options are displayed in the table, select the
check boxes in the Enable column for all security profiles that you want to enable.
e. Click Apply on the Bridging screen to activate your repeater settings.
3. Configure AP1 on LAN Segment 1 (see
remote MAC address of AP2.
4. Configure AP3 on LAN Segment 3 (see
remote MAC address of AP2.
Description
WPA-PSK TKIP (Temporal Key Integrity Protocol) is the standard
encryption method used with WPA-PSK and the only
selection possible from the Data Encryption drop-down list.
In the WPA Passphrase (Network Key) field, enter a
passphrase. The passphrase length needs to be between
8 and 63 characters (inclusive).
WPA2-PSK AES (Advanced Encryption Standard) is the standard
encryption method used with WPA2-PSK and the only
selection possible from the Data Encryption drop-down list.
In the WPA Passphrase (Network Key) field, enter a
passphrase. The passphrase length needs to be between
8 and 63 characters (inclusive).
Note:
with AES encryption if you want to use the 11n rates and
speed.
through Step h for any other security profile that you want to edit.
on page 127).
Figure 74
Figure 73
Figure 73
Advanced Configuration
130
NETGEAR recommends WPA2-PSK authentication
Figure 73
on page 128).
on page 127) in repeater mode with the
on page 127) in repeater mode with the
on page 127):